I cujt mh finger...

[Iceglow]

You've not cut yourself deeply with a razor til you've cut yourself with a cut-throat straight razor. I stupidly last year went to catch my razor after it fell off the side of the sink as I was lathering myself up with more soap. I say stupidly as my blade was exposed so I should have jumped back and let it go. Sure enough I reaction caught my razor in mid air, snagging it by the blade end. I got cuts across the inner part of the top knuckle on 3 fingers... how deep were the cuts? Oh, only to the bone. Thankfully, I was able to seal the cuts by using pressure then a spray plaster (these are the bomb for cuts, it literally feels like you've got a can of synth skin from a Sci-fi when you use them) but every time I flexed my fingers out I'd rip them back open for the first few days.

Using duct tape to cover a wound isn't as dumb as it first sounds. Your primary objective is to keep the cut clean which in a mechanics shop can be pretty difficult. Duct Tape is a waterproof seal. As such, putting a bandage and normal plaster on a wound then covering that in duct tape temporarily if your hands are likely to get very dirty or become exposed to dangerous liquids wouldn't be such a bad idea. I'd advise against it long term however, as the wound will not breathe and that will slow the healing process.

[Jessweeee♪]

i keep getting a paper cut on my cuticle from folding trout at work at lightning speed bceause i have to fold like 400 photocopis of prescribptions in like 5 minutes because i only have time after we close and i can't stay too late after that because my company doesn't allow overtime so after like two weeks of being too busy to do it until the last possible moment my cuticle just starts bleeding without me noticing and i have to throw out a prescriptions and scrub everything down because i have bled on it and that is not cool