Thanks

I agree the little dude doesn't fit perfectly well, it just started off as looking at what shapes were created by the print and then blossomed on into the angely guy.

Uh, the process behind this...I got a sheet of clear plastic and with a sharp screw (I was cheap and didn't get an etching tool) I etched into it a design based around some berries I had found...basically a few interlinked circles. I rolled on lots of printing ink, ran it thruogh a printing press with some paper and got a print. I kept doing that, experimenting with different inks, different ways of applying ink until I got bored and just lumped on a whole load of red and black ink, sprinkled it with talcum powder and printed it. I put on so much ink that it pretty much hid my original etch and gave all nice effects. Then I just photoshop'd over it somewhat.

Bit experimental, but yay....

Chaos